How to inject steroids

test name test last nameBlog

How to inject steroids

inject steroids

If you want to know how to inject steroids, the first thing you need to know is how to prepare for the injection. You know you need to stick it into the muscle tissue, and we’ll go into the specifics of that later on, but there’s more to it than that. There are eight specific steps you need to follow when injecting anabolic steroids, and while that may sound like a lot the whole process shouldn’t take but a minute. Failure to follow these eight remarkably simple steps can result in complications such as infections or simply very uncomfortable injections, and an unnecessarily sore injected area.

1. With regard to the syringe.
1) it must be new, in the package;
2) it must be clean (dropped or put the needle somewhere – nah throw out and print a new one);
3) it should not be air (this description);
4) the volume and length of the needle should be suitable – typically 5 standard syringe cubes is sufficient for even the most notorious tyazhelorogatomu character;
5) And finally – never used syringe and needle again after the injection of steroids or anything else!

2. Where inject steroids.
1) NEVER do injections VIENNA . This will cause DEATH .
2) There are three main places for injections :

  • the upper outer quarter of the gluteus maximus
  • the outer part of the thigh
  • delta

3. Preparations for injection and injection in the right buttock.
1) Prepare a syringe needle, wool alcohol, drug.
2) Wash your hands with soap and water as possible and place of future injections too.
3) If the drug is packaged in a vial, remove the cap and clean the rubber cap alcohol. If the drug in the vial, take a fine nail file and gently in a circular motion, the inscription around the neck. Then forwards to break off the neck of the ampoule. At the same time, so as not to injure the hands, the ampoule can be further wrapped with a napkin. The right shot in the buttock goes quickly and without sensation.
4) If you use the drug in vial
pull on the syringe plunger at a volume equal to a drug that you will use, enter the vial through the needle rubber cap and press the plunger, releasing the air into the vial. After reaching the end, flip vial upside down and slowly pulling the plunger, retracting the drug in the syringe. It needs to involve little more than is necessary for injection. The syringe, tap it, the bubbles gathered at the top, and to squeeze out part of the formulation with bubbles back into the vial. Shot in the right buttock will allow to achieve a greater effect on the exchange rate.
5) If you are using the drug in capsules

The sequence of actions is as follows:
– to break off at the tip of the ampoule
– to collect the contents of the syringe
– turn the syringe and tap it, the bubbles gathered at the top, – squeeze of the drug with bubbles outwardly

Inject steroids

4. Injection.
1) Wipe place future injections cotton wetted with alcohol.
2) Insert the needle into the injection site in one quick pressure.
3) Enter the drug.
4) Stretch needle.
5) cotton wool soaked alcohol wipe and massage the injection site.

5. shalt, for the pale!
All the waste left over from the procedures emissions.